8.3.3. Viewing setting and change access rights
Requirement: The parameter set is displayed in the parameterization window in enSuite. “Edit user
rights” has been selected in the “Configuration” tab. On the right-hand side of the parameterization
window, you can see the appropriate parameters in the “Parameters” tab. see following example.
The symbol bar is divided into two and consists of the following:
Buttons 1 to 5: rights for user profiles 1 to 5 . Each button has a unique symbol
assigned to it. The sequence corresponds to the position of the profiles in the user management. As
soon as a symbol has been enabled, the associated profile has the corresponding right.
There is no symbol for the administrator profile, as it must always have access rights.
Buttons 6 and 7: fiscal security settings . Button 6 is the symbol for protection by the
security switch (SSW) and button 7 is the symbol for the fiscal audit trail. Button 7 is only
displayed at parameter level. As soon as a symbol has been enabled, this security setting will be
valid.
Rights are managed using symbols,
and where rights or security settings have been allocated, a symbol will be displayed.
Only the administrator has access rights
if no symbol is displayed in the buttons 1 to 5.
Only the administrator can change the setting by clicking the icons or empty fields and then commit
his changes to the device. Changes not made by the administrator are rejected by the device after
transmission. The lines only serve as information display to all other users. The administrator can
define further user rights on the following page:
To Next Page
Loading...
Need help?
General
