Information for general use
Rev. M / 73023639
1.4. Version History Updates and File Integrity
The printed documentation enclosed with the device on delivery corresponds to the technical status
and is considered correct until updates are carried out. We reserve the right to make changes to the
device series and the documentation during further development. The following table gives an
overview of the latest changes in the version and device history.
for software versions 03-03-B to 03-08 A / Test and pre-series devices
1st version (ATEX and FM) for worldwide use; extension of I/O configuration and
service calibration /Adjustments to the grounding concept and pressure ranges.
New tranalation and title to use from version. 3-34-A/enSuite 4.5.1 Change to use a
concept, the appearance of displays, new document format /Extension explanation
of explosion protection /Additional Software security hints / New contents of CE
declaration
The german version L is identical with the english Version K to synchronize ther is no
English version L next Version is M for both languages and possible other
translations
Software / Hardware statuses included in documentation / Update control and data
security introduced / Remote control panel no longer accessible via http / Updates
for connection to device, parameterization and software configuration
This document (revision M) is also available online in PDF format for the duration of its validity and
can be downloaded from our Docuthek under the following link:
https://docuthek.kromschroeder.com/documents/index.php?menuid=29&topmenu=29&lang=de&selc
lass=&sellang=&folder=400082
The current enSuite version is available on the Elster-Instromet website. The firmware can be found
in the Gas Analysis subdirectory. A modification history, which is also available there, provides
information about development steps in the instrument series. You can access the page with the
following link:
https://www.elster-instromet.com/en/ensuite
Make sure to keep the device up to date and use the appropriate version of the documentation. From
time to time you should therefore check the above web pages to see if the hardware and software
used is still up to date.
If you have obtained this documentation in PDF format, e.g. after an update,
you can use the SHA-1 checksum information to test the file integrity.
The SHA-1 information can be found in the comment field of the Docuthek
or in brackets on the elster-Instromet page.
To Next Page
Loading...
