GASLAB Q2 DISPLAYS (OPERATE THE DEVICE)
Information for general use
Rev. M / 73023639
7.3.9. System display (overview)
The system display, a node to additional displays, is opened by selecting this symbol.
You can go to the following sub-displays
using this node:
Time Service,
Users,
Logbook,
Audit trail,
I/O.
Figure 7.25: System display
7.3.10. System display Time Service (System time and date)
The system time (permanent device-internal calendar with date and time) is saved on a battery-
buffered clock block. The time or system time is therefore available even after the device has been
switched off and on again.
Changing the system time is the generic term for both synchronization and for adjusting the date
and time.
The time service to output and change the device’s internal time has up to
four standard displays.
These displays will change depending on the parameterization and the user’s
login.(see section 7.3.11 System display Users (Login/Logout / Password)
and Configuration and analysis software enSuite)
The following figure shows the hierarchical structure and the navigation through the displays
To Next Page
Loading...
Need help?
General
