GASLAB Q2 DISPLAYS (OPERATE THE DEVICE)
Information for general use
Rev. M / 73023639
Entries in the error list must be accepted (see the following steps).
On delivery of the device, this is only possible
using the defined acceptance action if the cause of the entry has been rectified.
You may also require the appropriate rights.
You can change the acceptance action using Configuration and analysis software
enSuite. Details are also available in enSuite online help
Action: Clearing (accepting) the error list
Navigate to the Error List main display and open it.
(Click on Home >> Error List).
To accept only messages for a specific software part from the list, open the filter and
select the appropriate entry.
Select “Refresh” to update the list which had been frozen upon opening (number in
brackets = number of new messages).
Start the Accept all action. The selected list will be accepted and refreshed according
to the parameterized acceptance action.
Repeat these steps for other display texts from other software parts if necessary.
After all the entries have been accepted, the system will be returned to error-free status. The status
LED will be lit in green.
You can go straight to the logbook display from the error list display using the Logbook hyperlink.
The logbook will also log the start and end of all messages (alarms and warnings).
It is similar to an archive; each entry is assigned an ordinal number. The entries which have been
removed from the error list can be found here.
Honeywell provides assistance with troubleshooting work.
Contact data are provided at the start of this document.
To Next Page
Loading...
Need help?
General
