CONFIGURATION AND ANALYSIS SOFTWARE ENSUITE
Information for general use
Rev. M / 73023639
Figure 8.46: Update device’s date and time tab
To synchronize the system time of the device to the PC time enable the option Use PC local time –
the current PC time will be shown in square brackets.
Or to set the system time of the device yourself enable the option Use specified date and time –
default.
The date and time selection fields are pre-assigned
using the system time of the enCore device at the point at which
the user logged in; the date and time are not updated.
To assign the date and time selection fields again with the updated local PC time, click [Now].
Change the date in the date field and the time in the time field manually if necessary.
If the local PC time or the time you have selected is in daylight saving time select the checkbox
Daylight savings time.
Clicking [Update date and time] transfers your settings to the enCore device. The settings are
immediately saved by the device and then in the main display of the Time Service this update time
will be displayed as the Latest update value.
If the date and time could not be set successfully, enSuite will display a warning and the cause of
the error in the Output window. The cause of the error may be, for example, that the user has been
automatically logged out due to the Inactivity timeout
Tip: If the output window is not displayed in enSuite,
you can open it using the path Window – Output or the <Ctrl + 4> keyboard shortcut.
To Next Page
Loading...
