I
-
I
-
Getting Started
Entering Measurement Parameters
Entering Frequency
Range
1. Press the
LFREQ)
key to access the frequency
softkey
menu.
2.
lb change the low end of the frequency range to 10 MHz, press
S~;W&
Ilo]m.
3.
lb change the high end of the frequency range to 900 MHz, press
Stop
(EiJMHz.
4+
You can also set the frequency range by using the
CerSer
and Span
softkeys. For instance if you set the center frequency to 160 MHz and the
span to 300 MHz, the resulting frequency range would be 10 to 310 MHz.
NOTE
When entering frequencies, be sure to terminate Your numeric entry with the appropriate softkey to
obtain the correct units. If you use the
CENTER)
key to terminate a frequency entry, the units
default to Hz.
The default displayed frequency resolution is kHz. You can change the resolution by pressing
[FREQI
Disp
Fmq
Re&oLutictn
, and then selecting a new resolution.
2-7
-1
To Next Page
Loading...
Need help?
General
