User Fail Disk is marked failed at host's request.
Offline Disk is offline for some other reason.
Inactive Disk has been set inactive.
Not Syncd Data on disk is not synchronized with the rest of
the array.
Primary Disk is the primary disk for a 2 disk mirror and is
OK.
Secondary Disk is the secondary disk for a 2 disk mirror and
is OK.
Wrg Type Device is not compatible for use as part of an IM
array.
Too Small Disk is too small to mirror existing data.
Max Dsks Maximum # of disks allowed for this type of Array
reached and/or Maximum # of total IM disks on a
controller reached.
No SMART Disk doesn't support SMART, cannot be used in an
RAID array.
Wrg Intfc Device interface (SAS) differs from existing IM disks.
Pred Fail Indicates whether device SMART is predicting device failure (Yes, No).
Size (MB) Indicates the size of the device in megabytes (megabyte = 1024 x
1024 = 1,048,576). If the device is part of a two-disk array, this field
reflects the size of the array, not the size of the individual disk. If the
device is part of a three or more disk array, this field is the size that
the disk makes up within the array. When creating a striped array,
the usable size of the array is determined by the number of drives times
the size of the smallest drive in the array. In arrays consisting of
different sized drives, excess space on larger drives are unusable.
Manage Array Screen
The Manage Array screen enables you to manage the current array. To access the Manage Array
screen, select the appropriate field and press Enter on the Manage Array field from the View Array
screen.
The Manage Array screen enables you to perform the following actions:
Manage Hot Spare
To display a Hot Spare Management screen that has the same layout as the Create New Array
screen, press Enter on Manage Hot Spare. This field is grayed out under the following conditions:
• The array is inactive.
• The array is at its maximum number of devices.
• Non-IR firmware is used.
• IR is disabled. The array is inactive.
Synchronize Array
To perform a synchronization of the IM array, press Enter on Synchronize Array. The screen prompts
you to ask if you want to perform this action. Press Y for yes or N for no. This field is grayed out
under the following conditions:
• The array is inactive.
• The array does not need to be resynchronized.
• The adapter's MPT firmware does not support the feature
286 Core I/O Card Utilities
To Next Page
Loading...
Need help?
General
