To Next Page

To Previous Page

11-16

Port-Based Virtual LANs (VLANs) and GVRP

Port-Based Virtual LANs (Static VLANs)

VLAN Commands Used in this Section

Displaying the Switch’s VLAN Configuration. The next command lists

the VLANs currently running in the switch, with VID, VLAN name, and VLAN

status. Dynamic VLANs appear only if the switch is running with GVRP

enabled and one or more ports has dynamically joined an advertised VLAN.

(In the default configuration, GVRP is disabled. (See “GVRP” on page 11-33.)

Syntax: show vlan

Figure 11-12. Example of “Show VLAN” Listing (GVRP Enabled)

show vlans below

show vlan <vlan-id> page 11-17

max-vlans <1..30> page 11-18

primary-vlan <vlan-id> page 11-18

[no] vlan <vlan-id> page 11-19

name <vlan-name> page 11-20

[no] tagged <port-list> page 11-20

[no] untagged <port-list> page 11-20

[no] forbid page 11-20

auto <port-list> page 11-20 (Available if GVRP enabled.)

static-vlan <vlan-id> page 11-20 (Available if GVRP enabled.)

When GVRP is disabled

(the default), Dynamic

VLANs do not exist on

the switch and do not

appear in this listing.

(See “GVRP” on page

11-33.)

!Software.book Page 16 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General