To Next Page

To Previous Page

14-26

HP Procurve Stack Management

Configuring Stack Management

Using Any Stacked Switch To View the Status for All Switches with

Stacking Enabled. This procedure displays the general status of all switches

in the IP subnet (broadcast domain) that have stacking enabled.

1. Go to the console Main Menu for any switch configured for stacking and

select:

9. Stacking ...

2. Stacking Status (All)

You will then see a Stacking Status screen similar to the following:

Figure 14-18. Example of Stacking Status for All Detected Switches Configured for

Stacking

Viewing Commander Status. This procedure displays the Commander and

stack configuration, plus information identifying each stack member.

To display the status for a Commander, go to the console Main Menu for the

switch and select:

9. Stacking ...

1. Stacking Status (This Switch)

For status descriptions, see the table on page 14-46.

!Software.book Page 26 Thursday, October 10, 2002 6:10 PM

Other manuals for HP ProCurve 2650

Questions and Answers:

Need help?

Do you have a question about the HP ProCurve 2650 and is the answer not in the manual?

General