HP V1910 - Configuring SNMP Trap Function

125
Item Descri
p
tion
Group Name
Select an SNMP group to which the user belongs.
 When the security level is NoAuth/NoPriv, you can select an
SNMP group with no authentication no privacy.
 When the security level is Auth/NoPriv, you can select an
SNMP group with no authentication no privacy or
authentication without privacy.
 When the security level is Auth/Priv, you can select an SNMP
group of any security level.
Authentication Mode
Select an authentication mode (including MD5 and SHA) when the
security level is Auth/NoPriv or Auth/Priv.
Authentication Password
Set the authentication password when the security level is
Auth/NoPriv or Auth/Priv.
The confirm authentication password must be the same with the
authentication password.
Confirm Authentication Password
Privacy Mode
Select a privacy mode (including DES56, AES128, and 3DES)
when the security level is Auth/Priv.
Privacy Password Set the privacy password when the security level is Auth/Priv.
The confirm privacy password must be the same with the privacy
password.
Confirm Privacy Password
ACL
Associate a basic ACL with the user to restrict the source IP address
of SNMP packets, that is, you can configure to allow or prohibit
SNMP packets with a specific source IP address, so as to allow or
prohibit the specified NMS to access the agent by using this user
name.
Return to SNMPv3 configuration task list.
Configuring SNMP trap function
Table 38 Select Device  SNMP from the navigation tree.
Table 39 Click the Trap tab to enter the page as shown in b.
Table 40 On the upper part of the page, you can select to enable the SNMP trap function; on the lower part
of the page, you can configure target hosts of the SNMP traps.
Table 41 Click Add to enter the Add Trap Target Host page, as shown in c.