HP V1910 User Manual

33
Task Remarks
Configuring stack
ports
Required
Configure the ports of the master switch that connect to member
switches as stack ports.
By default, a port is not a stack port.
Configuring
member
switches of a
stack
Configuring stack
ports
Required
Configure a port of a member switch that connects to the master switch
or another member switch as a stack port.
By default, a port is not a stack port.
Displaying topology summary of a
stack
Optional
Display the information of stack members.
Displaying device summary of a stack
Optional
Display the control panels of stack members.
IMPORTANT:
Before viewing the control panel of a member switch, you must ensure
that the username, password, and access right you used to log on to the
master switch are the same with those configured on the member switch;
otherwise, the control panel of the member switch cannot be displayed.
Logging into a member switch from
the master switch
Optional
Log in to the web interface of a member switch from the master switch.
IMPORTANT:
Before logging into a member switch, you must ensure that the
username, password, and access right you used to log on to the master
switch are the same with those configured on the member switch;
otherwise, you cannot log into the member switch. You can configure
them by selecting Device and then clicking Users from the navigation
tree.
Configuring global parameters of a stack
Select IRF from the navigation tree to enter the page shown in a. You can configure global parameters of a
stack in the Global Settings area.

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP