HP V1910 User Manual

31
Item Descri
p
tion
BOOTP
DHCP.
 BOOTP: Specifies the VLAN interface to obtain an IPv4 address
through BOOTP.
 Manual: Allows you to specify an IPv4 address and a mask length.
IMPORTANT:
Support for IPv4 obtaining methods depends on the device model.
Manual
IPv4
address
Specify an IPv4 address and the mask length for the VLAN interface.
These two text boxes are configurable if Manual is selected.
MaskLen
Finishing configuration wizard
After finishing the management IP address configuration, click Next, as shown in a.
a. Configuration finishes
The page displays your configurations. Review the configurations and if you want to modify the settings
click Back to go back to the page. Click Finish to confirm your settings and the system then performs the
configurations.

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP