EasyManuals Logo

HP V1910 User Manual

HP V1910
483 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #280 background imageLoading...
Page #280 background image
268
Creating an IPv4 static route
Select Network IPv4 Routing from the navigation tree and click the Create tab to enter the IPv4 static route
configuration page, as shown in a.
a. Create an IPv4 static route
2. IPv4 static route configuration items
Item Descri
p
tion
Destination IP Address
Type the destination IP address of the static route, in dotted decimal notation.
Mask
Specify the mask of the destination IP address.
Select a mask length (number of consecutive 1s in the mask) or a mask in
dotted decimal notation from the drop-down list.
Preference
Type a preference value for the static route. The smaller the number, the higher
the preference.
For example, specifying the same preference for multiple static routes to the
same destination enables load sharing on the routes; specifying different
preferences enables route backup.
Next Hop Type the next hop IP address, in dotted decimal notation.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP V1910 and is the answer not in the manual?

HP V1910 Specifications

General IconGeneral
Switching Capacity56 Gbps
Forwarding Rate41.7 Mpps
ManageableYes
Form FactorRack-mountable
FeaturesVLAN, QoS, Link Aggregation
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% (non-condensing)
Ports24 x 10/100/1000 + 4 x SFP

Related product manuals