HP V1910 User Manual

267
Default route
A default route is used to forward packets that match no entry in the routing table. Without a default route,
the packet is discarded.
An IPv4 static default route has both its destination IP address and mask being 0.0.0.0.
Configuring IPv4 routing
Displaying the IPv4 active route table
Select Network  IPv4 Routing from the navigation tree to enter the page shown in a.
a. Active route table
2. Description of the fields of the active route table
Field Descri
p
tion
Destination IP Address Destination IP address of the route
Mask Mask of the destination IP address
Protocol Protocol that discovered the route
Preference
Preference value for the route
The smaller the number, the higher the preference.
Next Hop Next hop IP address of the route
Interface
Output interface of the route. Packets destined for the destination IP
address will be forwarded out the interface.

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP