HP V1910 User Manual

273
Precautions
When configuring a static route, note the following:
Table 73 If you do not specify the preference when configuring a static route, the default preference will be
used. Reconfiguration of the default preference applies only to newly created static routes. The web
interface does not support configuration of the default preference.
Table 74 The static route does not take effect if you specify the next hop address first and then configure it
as the IP address of a local interface, such as a VLAN interface.
Table 75 If Null 0 interface is specified as the output interface, the next hop address is not required. If you
want to specify a broadcast interface (such as a VLAN interface) as the output interface, which may
have multiple next hops, specify the next hop at the same time.
Table 76 You can delete only static routes on the Remove tab.

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP