HP V1910 User Manual

65
Port management configuration
You can use the port management feature to set and view the operation parameters of a Layer 2 Ethernet
port, including but not limited to its state, rate, duplex mode, link type, PVID, MDI mode, flow control settings,
MAC learning limit, and storm suppression ratios.
Configuring a port
Setting operation parameters for a port
Select Device  Port Management from the navigation tree, and then select the Setup tab on the page that
appears to enter the page as shown in a.
a. The Setup tab

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP