HP V1910 User Manual

413
Configuring a time range
Select QoS  Time Range from the navigation tree and then select the Create tab to enter the time range
configuration page, as shown in a.
a. The page for creating a time range
2 describes the configuration items for creating a time range.
2. Time range configuration items
Item Descri
p
tion
Time Range Name Set the name for the time range.
Periodic
Time Range
Start Time Set the start time of the periodic time range.
You can define
both a periodic
time range and
an absolute
time range to
create a
compound time
range. This
compound time
range recurs on
the day or days
End Time
Set the end time of the periodic time range. The end time must
be greater than the start time.
Sun, Mon,
Tue, Wed,
Thu, Fri,
and Sat.
Select the day or days of the week on which the periodic time
range is valid. You can select any combination of the days of
the week.
Absolute
Time Range
From
Set the start time and date of the absolute time range. The time
of the day is in the hh:mm format (24-hour clock), and the date
is in the MM/DD/YYYY format.

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP