HP V1910 User Manual

Task Descri
p
tion
Configuring RADIUS
accounting servers
Optional
Configure the information related to the primary and
secondary RADIUS accounting servers.
By default, no RADIUS accounting server is configured.
Configuring RADIUS
parameters
Required
Configure the parameters that are necessary for information exchange between the
device and RADIUS servers.
Configuring RADIUS servers
From the navigation tree, select Authentication  RADIUS. The RADIUS server configuration page appears,
as shown in a.
a. RADIUS server configuration
2. RADIUS server configuration
Item Descri
p
tion
Server Type
Specify the type of the server to be configured, which can be Authentication
Server and Accounting Sever.
Primary Server IP
Specify the IP address of the primary server.
If no primary server is specified, the text box displays 0.0.0.0.
To remove the previously configured primary server, enter 0.0.0.0 in the text
box.
The specified IP address of the primary server cannot be the same as that of the
secondary server.
Primary Server UDP Port
Specify the UDP port of the primary server.
If the IP address of the primary server is not specified or the specified IP address
is to be removed, the port number is 1812 for authentication or 1813 for
accounting.

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP