HP V1910 User Manual

85
Loopback test configuration
Overview
You can check whether an Ethernet port works normally by performing the Ethernet port loopback test,
during which the port cannot forward data packets normally.
Ethernet port loopback test can be an internal loopback test or an external loopback test.
 In an internal loopback test, self loop is established in the switching chip to check whether there is a
chip failure related to the functions of the port.
 In an external loopback test, a loopback plug is used on the port. Packets forwarded by the port will
be received by itself through the loopback plug. The external loopback test can be used to check
whether there is a hardware failure on the port.
Loopback operation
Select Device  Loopback from the navigation tree to enter the loopback test configuration page, as shown
in a.
a. Loopback test configuration page
2. Loopback test configuration items
Item Descri
p
tion
Testing
type
External
Set the loopback test type, which can be External or Internal.
Internal

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP