HP V1910 User Manual

160
Voice VLAN configuration examples
Configuring voice VLAN on a port in automatic voice VLAN
assignment mode
Network requirements
As shown in a,
 Configure VLAN 2 as the voice VLAN allowing only voice traffic to pass through.
 The IP phone connected to hybrid port GigabitEthernet 1/0/1 sends untagged voice traffic.
 GigabitEthernet 1/0/1 operates in automatic VLAN assignment mode. Set the voice VLAN aging
timer to 30 minutes.
 Configure GigabitEthernet 1/0/1 to allow voice packets whose source MAC addresses match the
OUI addresses specified by OUI address 0011-2200-0000 and mask FFFF-FF00-0000. The
description of the OUI address entry is test.
a. Network diagram for automatic voice VLAN assignment mode configuration
Switch A Switch B
GE1/0/3
GE1/0/1
VLAN 2
VLAN 2
010-1001
OUI: 0011-2200-0000
Mask: ffff-ff00-0000
0755-2002
Internet
Configuration procedure
# Create VLAN 2.
 Select Network  VLAN from the navigation tree, and click the Create tab to enter the page shown in
a.

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP