EasyManuals Logo

HP V1910 User Manual

HP V1910
483 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #383 background imageLoading...
Page #383 background image
a.
RADIUS parameter configuration
2. RADIUS parameters
Item Descri
p
tion
Server Type
Specify the type of the RADIUS server supported by the device,
including:
extended: Specifies an extended RADIUS server (usually a
CAMS or iMC server). That is, the RADIUS client and RADIUS
server communicate using the proprietary RADIUS protocol and
packet format.
standard: Specifies a standard RADIUS server. That is, the
RADIUS client and RADIUS server communicate using the
standard RADIUS protocol and packet format defined in RFC
2138/2139 or later.
Authentication Server Shared Key
Specify and confirm the shared key for the authentication server.
These two parameters must have the same values.
Confirm Authentication Shared Key
Accounting Server Shared Key
Specify and confirm the shared key for the accounting server. These
two parameters must have the same values.
Confirm Accounting Shared Key
NAS-IP
Specify the source IP address for the device to use in RADIUS packets
to be sent to the RADIUS server. It is recommended to use a loopback
interface address instead of a physical interface address as the
source IP address, because if the physical interface is down, the
response packets from the server cannot reach the device.
Timeout Interval Set the RADIUS server response timeout.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP V1910 and is the answer not in the manual?

HP V1910 Specifications

General IconGeneral
Switching Capacity56 Gbps
Forwarding Rate41.7 Mpps
ManageableYes
Form FactorRack-mountable
FeaturesVLAN, QoS, Link Aggregation
Operating Temperature0°C to 45°C
Operating Humidity10% to 90% (non-condensing)
Ports24 x 10/100/1000 + 4 x SFP

Related product manuals