HP V1910 User Manual

415
a.
The page for configuring an basic IPv4 ACL
2 describes the configuration items for creating a rule for a basic IPv4 ACL.
2. Configuration items for a basic IPv4 ACL rule
Item Descri
p
tion
Select Access Control List (ACL)
Select the basic IPv4 ACL for which you want to configure rules.
Available ACLs are basic IPv4 ACLs that have been configured.
Rule ID
Select the Rule ID option and type a number for the rule.
If you do not specify the rule number, the system will assign one
automatically.
Operation
Select the operation to be performed for IPv4 packets matching the
rule.
 Permit—Allows matched packets to pass.
 Deny—Drops matched packets.
Check Fragment
Select this option to apply the rule to only non-first fragments.
If you do no select this option, the rule applies to all fragments and
non-fragments.
Check Logging
Select this option to keep a log of matched IPv4 packets.
A log entry contains the ACL rule number, operation for the matched
packets, protocol that IP carries, source/destination address,
source/destination port number, and number of matched packets.
Source IP Address
Select the Source IP Address option and type a source IPv4 address

HP V1910 Specifications

General

Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Manageable	Yes
Form Factor	Rack-mountable
Features	VLAN, QoS, Link Aggregation
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (non-condensing)
Ports	24 x 10/100/1000 + 4 x SFP