IBM i 830

Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
8610 Air Moving Device B01 Not Present AIRMOVR
TWRCARD
8620 Air Moving Device B02 Not Present AIRMOVR
TWRCARD
8810 Battery Power Unit missing BATRY
8811 Battery Charger Unit missing BATCHGR
8910 External Netfinity Server 3.3V fault ALTMANL
TWRCARD
8920 External Netfinity Server Power Good fault TWRCARD
ALTMANL
8930 Integrated Netfinity Adapter fault TWRCARD
8940 to 8943 External Netfinity Server R485 Communication fault TWRCARD
CBLALL
ALTMANL
9012 Address not valid.
LIC command had a frame address that was not valid.
Exchange the SPCN frame-to-frame cables to the failing frame.
TWRCARD
CBLALL
9013 Invalid Node Address.
The address in the SPCN command does not match the secondary nodes
assigned address.
Exchange the failing items for the SPCN node reporting the error.
TWRCARD
CBLALL
9014 A command has an invalid address mode.
A command from the system unit specified a unit address of D or E or had
a frame address of 00.
Exchange the failing items in the system unit.
AJDG301
TWRCARD
9016, 9021 A command to an SPCN node was rejected.
No action required. This reference code is logged for information only.
9022 Addressed Unit not in frame.
The addressed unit does not exist in the addressed frame.
No action required. This reference code is logged for information only.
9023 Addressed Unit exists, but the frame is powered off.
The addressed unit is in a frame that is powered off.
No action required. This reference code is logged for information only.
9024 SPCN Licensed Internal Code not valid.
The Licensed Internal Code in one of the secondary nodes is not valid. The
code will be reloaded.
No action required. This reference code is logged for error analysis only.
1xxx
Chapter 2. Unit Reference Codes 107