IBM i 830 User Manual

Symptom Description INT-PIPs
System or
subsystem runs
slow.
The system or the subsystem is not processing at its normal
speed (for example, QBATCH).
“INT-PIP20 Performance
Problems” on page 339
If the symptom for the intermittent problem you have is not listed, go to “Failing
Area INT-PIP Table”.
Failing Area INT-PIP Table
Use this table only if you do not have an SRC or cannot find your symptom in the
“Intermittent Symptom Table” on page 20.
Note: Before performing any INT-PIPs in Table 2, first perform all of the steps in
“General Intermittent Problem Checklist” on page 16 for all failing areas.
1. Under Failing Area, find the area of failure.
2. Look down the column for the area of failure until you find an X. Look
across to the INT-PIP column and perform the INT-PIP indicated.
3. If the INT-PIP does not correct the intermittent problem, continue down
the column for the area of failure until you have performed all of the
INT-PIPs shown for the failing area.
Although an INT-PIP may correct the intermittent problem, use your best
judgment to determine if you should perform the remainder of the INT-PIPs
shown for the failing area.
Table 2. Failing Area INT-PIPs
Failing Area INT-PIP
Power WSIOP DASD
MSIOP
Comm Processor
Bus
Tape Optical Perform all steps in
XXX XXX“General Intermittent
Problem Checklist” on
page 16
XX X “INT-PIP5 External Noise on
Twinaxial Cables” on
page 333
XX XXX“INT-PIP7 Electromagnetic
Interference (EMI)” on
page 334
X “INT-PIP9 Utility Power and
Battery Power Units” on
page 336
X “INT-PIP14 Station
Protectors” on page 339
X “INT-PIP16 Licensed
Internal Code” on page 339
XX X X XX “INT-PIP18 PTFs Not
Installed” on page 339
XX X XX “INT-PIP20 Performance
Problems” on page 339
Intermittent Problems
Chapter 1. Starting Problem Analysis 21

IBM i 830 Specifications

General

Brand	IBM
Model	i 830
Category	Server
Language	English