b. Select the End Licensed Internal Code option.
Note: Remember that the file does not close until you select the End Licensed
Internal Code option.
This ends the procedure.
Verifying the Repair
1. Were you sent here after completing a concurrent maintenance procedure?
No Yes
↓ Go to “Verify Concurrent Repair” on page 921.
This ends the procedure.
2. Go to “Verify Dedicated Repair.”.
This ends the procedure.
Verify Dedicated Repair.
1. Perform the following:
a. Verify that the power cable is plugged into the power outlet.
b. Verify that power is available at the customer’s power outlet.
2. Select the IPL type and mode that the customer uses (see iSeries Service
Functions in “Powering On and Powering Off the System and Logical
Partitions” on page 922).
Note: If you select Normal mode when you power on the system, the Dedicated
service tools option will not be shown.
3. Start an IPL by powering on the system (see “Powering On and Powering Off
the System and Logical Partitions” on page 922).
Did the system complete the IPL?
Yes No
↓ This may be a new problem. Go to “Starting Point for All Problems” on
page 4.
This ends the procedure.
4. Use the service action log to look for any system reference codes (SRCs) that
are related to this IPL (see “Using the Service Action Log” on page 9).
Are there any SRCs that are related to this IPL?
Yes No
↓ Perform the “Verification Procedures” (in the Hardware Service
Manager chapter) in the iSeries Service Functions information to verify
that the problem is corrected.
The verification procedures only cover removable media,
communications and diskette problems.
Then return the system to the customer.
Ensure that the customer verifies the system date and time.
This ends the procedure.
5. Is the SRC the same as the original SRC?
Data Recovery and General System Information
920
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
To Next Page
Loading...
Need help?
General