During the IPL or mainstore dump of a secondary partition, a complex problem
was detected. The Primary partition’s SAL has to be searched or the SRC history
list in the primary partition for the secondary partition with the problem has to be
analyzed in sequence. If the secondary partition is a ″Guest″ partition, then the
SRC history list of the ″Hosting″ partition must be analyzed.
Contact your next level of hardware support.
This ends the procedure.
LSMEDIA
The load-source media is the failing item.
If the load-source is tape, exchange the tape in the alternate IPL tape unit. If
replacing the media does not work, try replacing the tape device unit.
If the load-source is an optical storage unit, exchange the compact disk. If replacing
the media does not work, try replacing the optical storage device unit.
If the load-source is disk, slip-install Licensed Internal Code back to the last known
working level. If this does not work, exchange the disk device unit.
This ends the procedure.
MABRCFG
MABRCFG: multi-adapter bridge configuration error.
The multi-adapter bridge hardware detected a configuration problem.
1. If you are working from the Service Action Log and there is a card position
that is listed with this failing item, then that is where the error is located,
continue with the next step in this procedure. Otherwise, to determine the card
location where the multi-adapter bridge configuration error is go to “BUS PIP
PCIBUS-PIP1” on page 320. Return here after locating the card.
2. Use the following table to determine the corrective action:
Problem or Message Meaning or Corrective Action
Multi-adapter bridge has no IOP for the I/O
adapters
System code detected one or more I/O
adapters under the multi-adapter bridge
specified in the DSA but no I/O processor to
control them. The I/O adapters are not
available to the system. To locate the I/O
adapters search for the card locations
controlled by the multi-adapter bridge
number in the DSA (see the “Card Position
Tables” on page 282 in the Bus PIP Overview
section of this document to determine all the
card locations controlled by the
multi-adapter bridge). To make the I/O
adapters available to the system install an
I/O processor under the multi-adapter
bridge to control the I/O adapters or move
the I/O adapters to an multi-adapter bridge
with an I/O processor.
Symbolic FRUs
552
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
To Next Page
Loading...
Need help?
General