IBM i 830 User Manual

Table 5. SRC exception table (continued)
First 4 characters of SRC What You Should Do
2809, 2810, 2824, 282C
These Storage IOA types are only allowed on migrated towers. See the Migrated
Expansion Tower Problem Analysis, Repair and Parts and follow the instructions in
the SRC table.
2842, 2843, 284B
Go to “(2749, 2767, 2768, 2842, 2843, 284B) Reference Codes” on page 124 and
follow the instructions in the SRC table.
283D, 283F
Go to “(283C, 283D, 283F) Device Backplane Reference Codes” on page 133 and
follow the instructions in the SRC table.
6381, 6382, 6383, 6386, 6387, 7207,
7208
Go to “(63A0) Tape Unit Reference Codes” on page 156 and follow the
instructions in the SRC table.
6532, 6533, 6534, 671A
These Storage IOA types are only allowed on migrated towers. See the Migrated
Expansion Tower Problem Analysis, Repair and Parts and follow the instructions in
the SRC table.
660x, 671x, 673x Go to “(432x, 660x, 671x, 673x) Disk Unit Reference Codes” on page 151 and
follow the instructions in the SRC table.
B1xx Service Processor terminating SRC
Go to “(A1xx, B1xx) Service Processor Reference Codes” on page 179 and follow
the instructions in the SRC table.
B9xx Go to “(A9xx, B9xx) Reference Codes” on page 183.
C9xx For information about these SRCs, see “Status SRCs” in the iSeries Service
Functions.
C1xx Service Processor IPL status
This is a normal reference code during the IPL of the system. You may suspect
that the IPL is not advancing correctly when the 6 rightmost characters do not
change for 2 minutes. The IPL may take longer with more I/O units and main
storage. Perform the following procedure if you suspect a problem:
1. See “IPL Status SRCs” in the iSeries Service Functions.
2. If there is still a problem, ask your next level of support for assistance.
C6xx, D6xx For information about these SRCs, see “Status SRCs” in the iSeries Service
Functions.
D1xx 3xxx Service Processor Main Storage Dump Status
This is a normal reference code showing the status of the system when
performing a main storage dump. You may suspect that the system is not
operating correctly when the rightmost characters do not change for 2 minutes.
Note: It takes approximately 1 minute to dump each 20MB of main storage. For
more information on main storage dumps, see Working with Storage Dumps in
the iSeries Service Functions information.
D1xx xxxx Service Processor General Status SRCs
If you suspect a problem, ask your next level of support for assistance.
EE60, F000 Go to “(0000) Control Panel Reference Codes” and follow the instructions in the
SRC table.
(0000) Control Panel Reference Codes
The control panel detected a failure.
Reference Code Tables
62
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1

IBM i 830 Specifications

General

Brand	IBM
Model	i 830
Category	Server
Language	English