Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
9101 Fibre Channel interface error detected
If the attached device is an external device, do the following before
exchanging any parts:
1. Ensure that the Fibre Channel cable is correctly connected to the ports.
2. Clean the Fibre Channel connectors.
3. If there is a hub attached, verify that the hub is operational.
4. If there is a gateway device attached, refer to the gateway device
service documentation for additional problem analysis procedures.
5. refer to the tape device service documentation for additonal problem
analysis procedures.
FCIOA
FCDEV
FCCABLE
9102 Gateway device detected a SCSI interface error
Use the gateway device service documentation to analyze the problem.
FI00851
FCGATE
EXTSCSI
61G8324
9200 I/O processor addressed the tape unit; no response
Before exchanging any parts, do the following:
1. Ensure that the device is powered on.
2. Ensure that an interposer is connected between the I/O processor and
the SCSI cable.
3. Ensure that the SCSI cable between the interposer and the device is
seated correctly, and that there are no bent or damaged pins on the
SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
FI00851
FI00131
05H3834
EXTSCSI
61G8324
9201 Tape unit command timeout
Before exchanging any parts, do the following:
1. Ensure that the device is powered on.
2. Ensure that an interposer is connected between the I/O processor and
the SCSI cable.
3. Ensure that the SCSI cable between the interposer and the device is
seated correctly, and that there are no bent or damaged pins on the
SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
FI00851
FI00131
05H3834
EXTSCSI
61G8324
9202 Tape unit failed after Licensed Internal Code was loaded
Before exchanging any parts, do the following:
1. Ensure that the device is powered on.
2. Ensure that an interposer is connected between the I/O processor and
the SCSI cable.
3. Ensure that the SCSI cable between the interposer and the device is
seated correctly, and that there are no bent or damaged pins on the
SCSI cable.
4. Ensure that a terminating plug is attached to the device end of the SCSI
cable.
FI00851
FI00131
05H3834
EXTSCSI
61G8324
9210 Illegal or unsupported tape unit response FI00851
FI00131
FI00130
3590
148
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
To Next Page
Loading...
Need help?
General