IBM i 830 User Manual

Reference Code Description/Action Perform all actions before exchanging Failing Items Failing Item
3002 I/O processor addressed the tape unit; no response
The tape unit did not respond to a command sent by the IOP.
1. Ensure that the tape unit is powered on. If the tape unit does not
become powered on, refer to the “Maintenance Analysis Procedures” in
the 7208 Model 2 8 mm Tape Drive Service Guide, SA23-2640, to analyze
the problem.
2. Switch off power to the tape unit.
3. Reseat the signal cable to the tape unit.
4. Reseat the signal cable to the IOP.
5. Switch on power to the tape unit.
91F0914
81F9128
FI00830
FI00141
91F0721
53F3861
42F7300
3005 Blank tape or BOT encountered
The tape unit has found blank tape or BOT.
When using a new data cartridge, the tape must first be initialized.
This error can also occur when reading a tape if the tape was removed
from the tape unit before writing was complete.
Also see the procedure for reference code FFFF.
MLVTMED
91F0914
AJEDA00
3010 Illegal or unsupported tape unit response
1. Look at the In-use lights. If the green light is off and the yellow light is
on, the tape unit is indicating an error condition.
2. Switch off power to the tape unit.
3. Switch on power to the tape unit.
4. Clean the recording head in the tape unit. Use the IBM Cleaning
Cartridge Kit (part 21F8593).
5. Use a new data cartridge if saving data.
Also see the procedure for reference code FFFF.
91F0914
AJEDA00
3100 IOP to tape unit interface error
1. Ensure that the tape unit is powered on. If the tape unit does not
become powered on, refer to the “Maintenance Analysis Procedures” in
the 7208 Model 2 8 mm Tape Drive Service Guide, SA23-2640, to analyze
the problem.
2. Switch off power to the tape unit.
3. Reseat the signal cable to the tape unit.
4. Reseat the signal cable to the IOP.
5. Switch on power to the tape unit.
91F0914
FI00141
FI00830
91F0721
42F7300
53F3861
81F9128
AJEDA00
3110 Tape unit command timeout
The tape unit did not complete a command sent by the IOP in the time
allowed.
1. Ensure that the tape unit is powered on. If the tape unit does not
become powered on, refer to the “Maintenance Analysis Procedures” in
the 7208 Model 2 8 mm Tape Drive Service Guide, SA23-2640, to analyze
the problem.
2. Switch off power to the tape unit.
3. Reseat the signal cable to the tape unit.
4. Reseat the signal cable to the IOP.
5. Switch on power to the tape unit.
91F0914
FI00141
FI00830
91F0721
42F7300
53F3861
81F9128
AJEDA00
7208
164
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1

IBM i 830 Specifications

General

Brand	IBM
Model	i 830
Category	Server
Language	English