IBM i 830

Reference
Code
Description/Action Perform all actions before exchanging
Failing Items
Failing Item Location
5126 Addressed device failed to respond to selection DISKDRV
STORIOA
DISKTRY
FI01106
FI01140
FI01141
DEVTERM
BACKPLN
5127 IOP timed out a disk command DISKDRV
STORIOA
FI01106
DISKTRY
FI01140
FI01141
DEVTERM
BACKPLN
5128 I/O processor failure FI01112
FI01107
512D An IOP dump was initiated
Copy the IOP dump entry and any related entries from the
Product Activity Log to suitable media, and give to an IBM
service representative.
512E System LIC program exception occurred
The system was inaDIPLmodewhentheproblemwas
detected. A main storage dump was not taken.
Perform “LIC-PIP1” on page 342.
AJDG301
FI00130
5206 System LIC detected a missing IOP LIC code load
System LIC detected a missing IOP LIC code load during IPL
of the IOP. This indicates that either the IOP code load is not
installed on the system load source device or that system LIC
was unable to successfully read that load from the load source
device.
Perform “LIC-PIP1” on page 342.
UG3USR1
5209 System LIC detected an IOP timeout during IOP IPL
Verify that all IOP cable connections are secure, and check tape
and other non-disk devices and media to verify that they are in
a ready state.
Perform “LIC-PIP1” on page 342.
UG3USR1
FI00130
AJDG301
5219 System LIC program exception occurred
An IOP signalled to system LIC that it had entered a critical
internal state. LIC automatically attempted to restart the IOP.
This reference code is logged for information only. No action is
required.
FI00310
FI00318
FI00065
FI00130
AJDG301
B6xx (including A6xx)
250
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1