b. Use the location information of the IOA in the Service Action Log if it is
available. If the location is not available, find the address. See “SRC Address
Formats” on page 936. Use the address to find the location. See “Locations
and Addresses” on page 705.
c. Find the IOA card in the system and read the type number of the card at
that location.
2. Find the IOA type, the attached device, the cable length, and the cable part
number in the following list.
Note: Verify that the part number in the list is the same as the part number on
the cable.
3. For external devices that are not found in the following list, use the device
type and refer to the appropriate service documentation for that device. The
service documentation for that device will help you determine the FRU part
numbers and replacement procedures you are to use during this repair action.
If you are unable to locate the documentation for your specific device, then
contact your next level of support for assistance.
IOP or IOA Type Device Lengths Part Number
2749 3490, 3490/Exx, 3590 2.8 meters 05H4647
4.5 meters 05H4648
12.0 meters 05H4649
18.0 meters 05H4650
25.0 meters 05H4651
3490/Fxx, 3570, 358x, 9427,
7208/342
0.5 meters 49G6456
4.5 meters 49G6457
12.0 meters 49G6458
18.0 meters 49G6459
63A0 See device documentation
to determine cable Part
Number(s)
7208/012, 7208/222 1.5 meters 52G0174
4.0 meters 59H3462
12.0 meters 59H3463
7208/232, 7208/234, 9348 0.5 meters 06H6037
4.0 meters 59H3460
12.0 meters 59H3461
3995 12.0 meters 59H3461
2768 7207/122, 7208/345,
7210/020, 7329/308
2.4 meters 67G1260
Note: All cables for the 9427 tape library must include an interposer, part
05H3834, on the device end of the cable.
This ends the procedure.
Symbolic FRUs
536
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1
To Next Page
Loading...
Need help?
General