IBM i 830

↓ Prior to exchanging any parts, verify that the processors are installed.
If you are in test mode and have removed all of the processors,
disregard this SRC. Otherwise, correct the processors. If the processors
are installed correctly, then exchange the following parts:
v Control panel (See symbolic FRU “CTLPNL” on page 524 for the
correct part.)
v For Models 840, and SB3:
– CLCKCRD (See symbolic FRU “CLCKCRD” on page 522 for the
correct part.)
– Cable connecting the system unit and the FC 9079 - part number
44L0007
v For Models 830, and SB2:
– CLCKCRD (See symbolic FRU “CLCKCRD” on page 522 for the
correct part.)
This ends the procedure.
3. Is the SRC 1xxx 8403?
No Yes
↓ Exchange the following parts:
v Tower card (See symbolic FRU “TWRCARD” on page 601 for the
correct part.)
v Processor 1 (See symbolic FRU “CCIN” on page 515 for the correct
part.)
This ends the procedure.
4. Is the SRC 1xxx 8404?
No Yes
↓ Exchange Processor 2 (See symbolic FRU “CCIN” on page 515 for the
correct part.)
This ends the procedure.
5. Is the SRC 1xxx 8405?
No Yes
↓ Exchange Processor 3 (See symbolic FRU “CCIN” on page 515 for the
correct part.)
This ends the procedure.
6. Is the SRC 1xxx 8406?
No Yes
↓ Exchange Processor 4 (See symbolic FRU “CCIN” on page 515 for the
correct part.)
This ends the procedure.
7. Is the SRC 1xxx 8409?
No Yes
↓ No processors are installed. If you are in test mode and have removed
all the processors, disregard this SRC. Otherwise, correctly install the
processors.
If the processors are installed correctly, exchange the following parts:
Symbolic FRUs
610
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1