Note: If this password is not valid, ask the customer for the correct
password.
c. Select the Work with disk units option on the Use Dedicated Service Tools
(DST) display.
d. Select the Work with disk unit recovery option on the Work with Disk Unit
display.
e. Select the Restore disk unit data option on the Work with Disk Unit
Recovery display.
f. Enter the tape volume identifier. This is the volume identifier that you
entered during the save procedure.
g. Install the first tape that the data was saved to in the tape unit.
h. Select the tape unit that you want the data restored from on the Select
Tape Unit display.
i. Select the disk unit that you want the data restored to on the Restore Disk
Unit Data display.
j. Press F10 to confirm the restore.
The Function Status display shows the percent of customer data restored.
Note: When the load-source disk is restored, the system automatically
performs an IPL to the Use Dedicated Service Tools (DST) display.
This occurs after the restore operation completes.
When all customer data from the tape to the disk restores successfully, the
display shows that the status of the restore operation is complete.
k. Press the Enter key to complete the restore operation.
l. Power off the system.
Note: Any damaged objects that were restored must be loaded again by
the customer (have the customer see the Backup and Recovery
information).
The system is ready for the next IPL.
This ends the procedure.
15. Perform an IPL from removable media and select the option to install
Licensed Internal Code and recover configuration. (See “Installing Licensed
Internal Code” in the iSeries Service Functions information, which performs an
IPL and installs the Licensed Internal Code.)
16. Did you get a Disk Configuration Error Report with a ″Unit has incorrect
logical partition configuration″ warning?
No Yes
↓ You have logical partitions that need to be recovered before you can
continue with this disk unit recovery procedure. Perform the
following:
a. Enter the Use Dedicated Service Tools (DST) option from the IPL
or Install the System display.
b. Enter the password 22222222.
Note: If this password is not valid, ask the customer for the
correct password.
Data Recovery and General System Information
Chapter 6. Data Recovery Procedures and General System Information 907
To Next Page
Loading...
