IBM i 830

In the above example, the contents of “Storage” are defined as follows:
Reference
Description
I/O Bus
This is the SCSI bus to which the device is connected.
I/O Adapter
This is the adapter that the I/O bus connects to on the I/O processor.
Controller
This is the logical controller for the addressed device.
Device
This is the logical device that is attached to the logical device controller.
11. Use Figure 63 on page 939 to understand how addresses in the
Bus/Board/Card format relate to the Bus-Bus-Bus-Bus/Card-Card/Board-
Board format. You can also use Figure 63 on page 939 to understand how
addresses in the Bus/Board/Card format relate to the direct select addresses
used in “Locations and Addresses” on page 705.
Display Address Information for Resource
Serial Resource
Name Type Model Number Name
Storage 6607 050 83-00834 DD001
Physical Location
Frame ID .......: 1
Device Position....: L01
Logical Address:
SPD Bus: Storage:
System Bus ......: 1 I/OAdapter......: 0
System Board .....: 0 I/OBus........: 0
System Card......: 1 Controller.......: 1
Device ........: 0
Figure 62. Product Activity Log display example
SRC Address Formats
938
iSeries Model 830, 840, SB2, and SB3 Problem Analysis, Repair and Parts V5R1