Inficon SQC-310

4 - 17
PN 074-550-P1C
SQC-310 Operating Manual
The First Layer is the layer number of the first layer in the process. Subsequent
layers are found by reading the Next Layer parameter (see section 4.3.5).
4.3.4.1 Get/Set Process Parameter Examples
Get Process 1 name:
Command: !'C1? 1(58)(90)
Response: !4AProcess1 (90)(42)
Set Process 1 name:
Command: !.C1 1,AnyName(135)(34)
Response: !$A5 (53)(151)
To create a new process:
Command: !(CA1? 1(115)(124)
Response: !(A1,1 (58)(116)
To cut a layer from a process:
Command: !*CB1 2? 1(151)(79)
Response: !(A1,1 (58)(116)
To insert a NonCodepositon layer into a process:
Command: !,CC1 2 1? 1(84)(159)
Response: !(A1,1 (58)(116)
Table 4-5 Get/Set process parameters
Cmd ID Description Parameters
C Gets/sets the process parameters.
1 Process Name
2 Number of Layers
3 First Layer
4 Actual Layers
CA Performs a process specific
command.
1 Create a New Process
2 Delete a Process
3 Delete All Layers in this process
4 Check this Process (1 is process is OK)
CB Performs a process & layer location
specific command.
Message format changes to:
CB[Process#][LayerPosition#]?
[Parameter]
1 Cut this layer from this process
CC Performs a process, layer location
and film specific command.
Message format changes to:
CC[Process#] [LayerPosition#]
[Film#]?[Parameter]
1 Insert a NonCoDep layer in this process
2 Insert a CoDep layer in this process