4 - 2
PN 074-550-P1C
SQC-310 Operating Manual
4.1.2 USB Port
USB drivers are installed automatically with installation of the SQC-310 Comm
software. Once the drivers are installed, Windows will find and install SQC-310
when connected to a USB port.
In the event that an unsigned driver window displays during installation, click
Continue anyway. Successful communication can be confirmed using the
SQC-310 Comm software.
4.1.3 Ethernet (TCP/IP) Port
For Ethernet communications, SQC-310 uses the static Internet Protocol (IP)
address 192.168.1.200. The optional TCP/IP interface supports only the Standard
Ethernet TCP/IP protocol. SQC-310 will communicate using TCP/IP on TCP port
number 2101.
The interface supports static addressing. DHCP is not supported. Ethernet
parameters allow the IP address and the net mask to be set. A standard Ethernet
cable is required to connect SQC-310 through a network or hub connection.
4.1.3.1 Ethernet Network Protocol
An IP address defines the computer on the Internet. Most computers are
configured to automatically obtain the IP address from a server. Most computers
will auto-configure and work with either a straight or crossover Ethernet cable.
To communicate directly with SQC-310, the IP address must be manually
configured on the computer, and the computer and SQC-310 must be connected
using an Ethernet cable. To manually configure the IP address:
Follow section 4.1.3.1.1 for instructions to access network settings in Windows XP.
Follow section 4.1.3.1.2 on page 4-6 for instructions to access network settings in
Windows 7 and Windows 8.
NOTE: The above instructions will set two values—the IP address and the Subnet
mask—which may prohibit access to the Internet. If these values already
contain information, make a record of the information for use in restoring
the Internet connection.
NOTE: If the computer only has one Ethernet port (one network connection),
setting the computer for direct communications will prohibit it from
accessing the Internet until the setting is reversed.
SQC-310 ships with a pre-assigned address of 192.168.1.200. To communicate
directly with SQC-310 from a computer, the computer must also be assigned a
192.168.1.xxx address, but cannot be set to 192.168.1.200. The examples in
section 4.1.3.1.1 and section 4.1.3.1.2 use the address 192.168.1.201 for the
computer. The Subnet mask 255.255.0.0 is sufficient.
To Next Page
Loading...
Need help?
General
