3 - 35
PN 074-550-P1C
SQC-310 Operating Manual
Films: The film condition is evaluated true whenever the current film number
equals the specified film number. Choose film 1 to 50.
NOTE: References to sensor 1 to 4, source 1 to 4, relay 1 to 16, or input 1 to 16
assume SQC-310C or SQC-310 is equipped with the 4-channel option
card. Units not equipped with the option card will have sensor 1 to 2,
source 1 to 2, relay 1 to 8, and input 1 to 8.
3.12.2.3 Logic Statement Actions (THEN)
General Actions: A selection of actions that do not fit into another category.
Available actions include:
No Action
Manual
Hold in State
Step From State
Interlock
Sensor & Sources: Actions related to moving multi-crystal sensors and
multi-pocket sources. Available actions include:
Switch Crystal (choose sensor 1 to 4)
Move Snsr to Next Position (choose sensor 1 to 4)
Move Src to Next Pocket (choose source 1 to 4)
Relays: Activate one of the SQC-310 relays (choose relay 1 to 16).
SoftNodes: Sets a SoftNode to true (choose SoftNode 1 to 8).
Timers: Start a timer (choose timer 1 to 8).
Alarms: Activate one of the SQC-310 alarms. Alarm options include:
Attention (least severe)
Alert (more severe)
Alarm (most severe)
Process Actions: Start or Reset current process, or select process 1 to 100.
Layer Actions: Perform an action on the current layer. Available actions include:
Start Layer
Start Next Layer
Stop Layer
Force Final Thickness
Zero Thickness
Zero Time
Soak Hold
To Next Page
Loading...
Need help?
General
