3 - 18
PN 074-550-P1C
SQC-310 Operating Manual
Press Edit to display the setup parameters for the selected film.
3.11 Film Edit Menu
Rotate the control knob to scroll through parameters. Press the control knob to
select a parameter value to edit. While parameter value is highlighted, rotate the
control knob counterclockwise or clockwise to change the value. Press the control
knob to save the desired change for the selected parameter.
Figure 3-13 Film Edit menu
Delete Deletes the selected film.
NOTE: Films cannot be deleted if they are used in any process.
Copy/Paste Copies the selected film. Scroll to a film labeled as <Empty> and
press the Paste button to paste the copied film. The Paste button
appears after the Copy button is selected.
Create Available only when an undefined film (labeled as <Empty>) is
selected. This button defines the empty slot as a film and assigns it
a film number, allowing it to be used in a process.
Table 3-8 Film Select menu buttons (continued)
To Next Page
Loading...
Need help?
General
