- Untag: outgoing frames without VLAN-Tagged.
- Tagged: outgoing frames with VLAN-Tagged.
• Q-in-Q Mode
Sets the Managed Switch to QinQ mode, and allows the QinQ
tunnel port to be configured. The default is for the Managed
Switch to function in Disable mode.
- Disable: The port operates in its normal VLAN mode. (This is
the default.)
- MAN Port: Configures IEEE 802.1Q tunneling (QinQ) for an
uplink port to another device within the service provider
network.
- Customer Port: Configures IEEE 802.1Q tunneling (QinQ) for a
client access port to segregate and preserve customer VLAN
IDs for traffic crossing the service provider network.
Set Out layer VLAN
tag ether type
The Tag Protocol Identifier (TPID) specifies the ethertype of
incoming packets on a tunnel access port.
- 802.1Q Tag: 8100
- vMAN Tag: 88A8
Default : 802.1Q Tag
The port must be a member of the same VLAN as the Port VLAN ID.
Buttons
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved values.
To Next Page
Loading...
Need help?
General
