Keithley 2651A

Model 2651A High Power System SourceMeter® Instrument Reference Manual Section 5: Remote commands
2651A-901-01 Rev. A / March 2011 5-9
LAN and LXI
The LAN commands has options that allow you to review and configure network settings.
The lan.config.* commands allow you to configure LAN settings over the remote interface. Note
that you must send lan.applysettings() in order for the configuration settings to take effect.
The lan.status.* commands help you determine the status of the LAN.
The lan.trigger[N].* commands allows you to set up and assert trigger events that are sent
over the LAN.
Other LAN commands allow you to reset the LAN, restore defaults, check LXI domain information,
and enable or disable the Nagle algorithm.
lan.applysettings()
(on page 7-103)
lan.autoconnect
(on page 7-104)
lan.config.dns.address[N]
(on page 7-104)
lan.config.dns.domain
(on page 7-105)
lan.config.dns.dynamic
(on page 7-106)
lan.config.dns.hostname
(on page 7-107)
lan.config.dns.verify
(on page 7-107)
lan.config.duplex
(on page 7-108)
lan.config.gateway
(on page 7-108)
lan.config.ipaddress
(on page 7-109)
lan.config.method
(on page 7-110)
lan.config.speed
(on page 7-110)
lan.config.subnetmask
(on page 7-111)
lan.linktimeout
(on page 7-112)
lan.lxidomain
(on page 7-113)
lan.nagle
(on page 7-113)
lan.reset()
(on page 7-114)
lan.restoredefaults()
(on page 7-114)
lan.status.dns.address[N]
(on page 7-115)
lan.status.dns.name
(on page 7-116)
lan.status.duplex
(on page 7-117)
lan.status.gateway
(on page 7-117)
lan.status.ipaddress
(on page 7-118)
lan.status.macaddress
(on page 7-118)
lan.status.port.dst
(on page 7-119)
lan.status.port.rawsocket
(on page 7-119)
lan.status.port.telnet
(on page 7-120)
lan.status.port.vxi11
(on page 7-120)
lan.status.speed
(on page 7-121)
lan.status.subnetmask
(on page 7-121)
lan.timedwait
(on page 7-122)
lan.trigger[N].assert()
(on page 7-122)
lan.trigger[N].clear()
(on page 7-123)
lan.trigger[N].connect()
(on page 7-124)
lan.trigger[N].connected
(on page 7-124)
lan.trigger[N].disconnect()
(on page 7-125)
lan.trigger[N].EVENT_ID
(on page 7-126)
lan.trigger[N].ipaddress
(on page 7-126)