Keithley 2651A

Model 2651A High Power System SourceMeter® Instrument Reference Manual Section 7: Command reference
2651A-901-01 Rev. A / March 2011 7-115
Details
The settings that are restored are shown in the following table.
Settings that are restored to default
Attribute Default setting
lan.autoconnect lan.ENABLE
lan.config.dns.address[N] "0.0.0.0"
lan.config.dns.domain ""
lan.config.dns.dynamic lan.ENABLE
lan.config.dns.hostname ""
lan.config.dns.verify lan.ENABLE
lan.config.duplex lan.FULL
lan.config.gateway "0.0.0.0"
lan.config.ipaddress "192.168.0.2"
lan.config.method lan.AUTO
lan.config.speed 100
lan.config.subnetmask "255.255.255.0"
lan.linktimeout
20 (seconds)
lan.lxidomain 0
lan.nagle lan.ENABLE
lan.timedwait
20 (seconds)
The lan.restoredefaults() function does not reset the LAN password. The localnode.password
attribute controls the web password, which can be reset separately.
This command is run when lan.reset() is sent.
Example
lan.restoredefaults()
Restores the LAN defaults.
Also see
lan.reset() (on page 7-114)
localnode.password
(on page 7-134)
lan.status.dns.address[N]
This attribute contains the DNS server IP addresses.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R) Yes Not applicable Not applicable Not applicable
Usage
dnsAddress = lan.status.dns.address[N]
dnsAddress
DNS server IP address
N
Entry index (1, 2, or 3)