Appendix C: LAN concepts and settings Model 2651A High Power System SourceMeter® Instrument Reference Manual
C-2 2651A-901-01 Rev. A / March 2011
If you have problems, see LAN troubleshooting suggestions (on page 8-6).
CAUTION
Record all network configurations before modifying any existing network configuration information on
the network interface card. Once the network configuration settings are updated, the older information
is lost. This may cause a problem reconnecting the host computer to a corporate network, particularly
if DHCP Enabled = NO (disabled).
Be sure to return all settings to their original configuration before reconnecting the host computer to a
corporate network. Failure to do this could result in damage to the equipment and loss of data.
Contact your system administrator for more information.
Step 1: Identify and record the existing IP configuration
To identify the existing IP configuration:
1. Open a command prompt window:
Windows 2000 or Windows XP:
a. Click Start and select Run.
b. In the Open box, type cmd.
c. Click OK.
Windows Vista or Windows 7:
a. Click Start.
b. Select All Programs > Accessories > Command Prompt.
To Next Page
Need help?
General
