Section 7: Command reference Model 2651A High Power System SourceMeter® Instrument Reference Manual
7-112 2651A-901-01 Rev. A / March 2011
lan.linktimeout
This attribute contains the LAN link timeout period.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes LAN restore defaults Nonvolatile memory 20
Usage
timeout = lan.linktimeout
lan.linktimeout = timeout
timeout
The LAN link monitor time-out period (in seconds).
Details
You must enable the command lan.autoconnect before you can use this attribute.
The timeout value represents the amount of time that passes before the instrument disconnects from the LAN
due to the loss of the LAN link integrity.
The LAN interface does not disconnect if the connection to the LAN is reestablished before the timeout value
expires.
If the LAN link integrity is not restored before the timeout value expires, the instrument begins to monitor for a
new connection.
Example
print(lan.linktimeout)
Outputs the present LAN link timeout setting.
Also see
lan.autoconnect (on page 7-104)
lan.restoredefaults()
(on page 7-114)
To Next Page
Loading...
