To Next Page

To Previous Page

Section 7: Command reference Model 2651A High Power System SourceMeter® Instrument Reference Manual

7-110 2651A-901-01 Rev. A / March 2011

Also see

lan.restoredefaults() (on page 7-114)

lan.status.ipaddress

(on page 7-118)

lan.config.method

This attribute contains the LAN settings configuration method.

Type TSP-Link accessible Affected by Where saved Default value

Attribute (RW) Yes LAN restore defaults Nonvolatile memory lan.AUTO

Usage

method = lan.config.method

lan.config.method = method

method

The method for configuring LAN settings; it can be one of the following

values:

0 or lan.AUTO: Selects automatic sequencing of configuration methods

1 or lan.MANUAL: Use only manually specified configuration settings

Details

This attribute controls how the LAN IP address, subnet mask, default gateway address, and DNS server

addresses are determined.

When method is lan.AUTO, the instrument first attempts to configure the LAN settings using dynamic host

configuration protocol (DHCP). If DHCP fails, it tries dynamic link local addressing (DLLA). If DLLA fails, it uses

the manually specified settings.

When method is lan.MANUAL, only the manually specified settings are used. Neither DHCP nor DLLA are

attempted.

Example

print(lan.config.method)

Outputs the current method.

For example:

1.00000e+00

Also see

lan.restoredefaults() (on page 7-114)

lan.config.speed

This attribute contains the LAN speed used when restarting in manual configuration mode.

Type TSP-Link accessible Affected by Where saved Default value

Attribute (RW) Yes LAN restore defaults Nonvolatile memory 100

Keithley 2651A Reference Manual

Other manuals for Keithley 2651A