Keithley 2651A

Section 7: Command reference Model 2651A High Power System SourceMeter® Instrument Reference Manual
7-108 2651A-901-01 Rev. A / March 2011
Details
When this is enabled, the instrument performs DNS lookups to verify that the DNS host name matches the value
specified by lan.config.dns.hostname.
Example
print(lan.config.dns.verify)
Outputs the present DNS host name verification
state.
If it is enabled, the output is:
1.00000e+00
Also see
lan.config.dns.hostname (on page 7-107)
lan.restoredefaults()
(on page 7-114)
lan.config.duplex
This attribute defines the LAN duplex mode.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes LAN restore defaults Nonvolatile memory lan.FULL
Usage
duplex = lan.config.duplex
lan.config.duplex = duplex
duplex
LAN duplex setting can be one of the following values:
1 or lan.FULL: Selects full-duplex operation
0 or lan.HALF: Selects half-duplex operation
Details
This attribute does not indicate the actual setting currently in effect. Use the lan.status.duplex attribute to
determine the current operating state of the LAN.
Also see
lan.restoredefaults() (on page 7-114)
lan.config.gateway
This attribute contains the LAN default gateway address.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes LAN restore defaults Nonvolatile memory "0.0.0.0"