Keithley 2651A

Model 2651A High Power System SourceMeter® Instrument Reference Manual Section 6: Instrument programming
2651A-901-01 Rev. A / March 2011 6-63
These advantages make using TSP-Link connections to control another TSP-enabled device the best
choice for most applications. However, if the distance between the Model 2651A and the TSP-
enabled device is longer than 15 feet, use TSP-Net commands.
To establish a remote TSP-Net connection with a TSP-enabled device, use tspnet.connect()
without specifying a port number. The Model 2651A enables TSP prompt and error handling for the
remote device, which allows you to successfully use the commands listed in Instrument commands:
TSP-enabled device control (on page 6-63) to load and run scripts and retrieve reading buffers.
Abort any operation on the remote TSP-enabled device using the tspnet.tsp.abort() command.
Instrument commands: General device control
The following instrument commands provide general device control:
tspnet.clear() (on page 7-361)
tspnet.connect() (on page 7-361)
tspnet.disconnect() (on page 7-363)
tspnet.execute() (on page 7-363)
tspnet.idn() (on page 7-364)
tspnet.idn() (on page 7-364)
tspnet.read() (on page 7-365)
tspnet.readavailable() (on page 7-366)
tspnet.reset() (on page 7-366)
tspnet.termination() (on page 7-367)
tspnet.timeout (on page 7-368)
tspnet.write() (on page 7-371)
Instrument commands: TSP-enabled device control
The following instrument commands provide TSP-enabled device control:
tspnet.tsp.abort() (on page 7-368)
tspnet.tsp.abortonconnect (on page 7-369)
tspnet.tsp.rbtablecopy() (on page 7-369)
tspnet.tsp.runscript() (on page 7-370)