Keithley 2651A Reference Manual

Model 2651A High Power System SourceMeter® Instrument Reference Manual Section 7: Command reference
2651A-901-01 Rev. A / March 2011 7-109
Usage
gatewayAddress = lan.config.gateway
lan.config.gateway = gatewayAddress
gatewayAddress
LAN default gateway address; must be a string specifying the default
gateway’s IP address in dotted decimal notation
Details
This attribute specifies the default gateway IP address to use when manual or DLLA configuration methods are
used to configure the LAN. If DHCP is enabled, this setting is ignored.
This attribute does not indicate the actual setting currently in effect. Use the lan.status.gateway attribute to
determine the current operating state of the LAN.
The IP address must be formatted in four groups of numbers each separated by a decimal.
Example
print(lan.config.gateway)
Outputs the default gateway address. For example,
you might see the output:
010.060.008.001
Also see
lan.status.gateway (on page 7-117)
lan.restoredefaults()
(on page 7-114)
lan.config.ipaddress
This attribute specifies the LAN IP address.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes LAN restore defaults Nonvolatile memory "192.168.0.2"
Usage
ipAddress = lan.config.ipaddress
lan.config.ipaddress = ipAddress
ipAddress
LAN IP address; must be a string specifying the IP address in dotted decimal
notation
Details
This attribute specifies the LAN IP address to use when the LAN is configured using the manual configuration
method. This setting is ignored when DLLA or DHCP is used.
This attribute does not indicate the actual setting currently in effect. Use the lan.status.ipaddress attribute
to determine the current operating state of the LAN.
Example
ipaddress = lan.config.ipaddress
Retrieves the presently set LAN IP address.

Keithley 2651A Specifications

General

Brand	Keithley
Model	2651A
Category	Measuring Instruments
Language	English