To Next Page

To Previous Page

Model 2651A High Power System SourceMeter® Instrument Reference Manual Section 7: Command reference

2651A-901-01 Rev. A / March 2011 7-369

Example

tspnet.tsp.abort(myConnection)

Stops myConnection.

Also see

None

tspnet.tsp.abortonconnect

This attribute contains the setting for abort on connect.

Type TSP-Link accessible Affected by Where saved Default value

Attribute (RW) Yes Instrument reset Not saved 1 (enabled)

Usage

tspnet.tsp.abortonconnect = value

value = tspnet.tsp.abortonconnect

value

1 (enable) or 0 (disable)

Details

This setting determines if the instrument sends an abort message when it attempts to connect to a TSP-enabled

instrument using the tspnet.connect() function.

When you send the abort command on an interface, it causes any other active interface on that instrument to

close. If you do not issue an abort command (or if tspnet.tsp.abortonconnect is set to 0) and another

interface is active, connecting to a TSP-enabled remote instrument results in a connection. However, the

instrument will not respond to subsequent reads or executes because control of the instrument is not obtained

until an abort command has been issued. See Communications interfaces

(on page 2-73).

Example

tspnet.tsp.abortonconnect = 0

Configure the instrument so that it does not

send an abort command when connecting to

a TSP-enabled instrument.

Also see

tspnet.connect() (on page 7-361)

tspnet.tsp.rbtablecopy()

This function copies a reading buffer synchronous table from a remote instrument.

Type TSP-Link accessible

Affected by Where saved Default value

Function Yes

Keithley 2651A Reference Manual

Other manuals for Keithley 2651A