Model 2651A High Power System SourceMeter® Instrument Reference Manual Appendix C: LAN concepts and settings
2651A-901-01 Rev. A / March 2011 C-3
2. At the command prompt, type ipconfig/all and press the Enter key. A list of existing IP
configuration information for your computer is displayed.
Figure 120: Computer IP configuration using the command prompt
Network card
Subnet Mask
255.255.255.0
IP Address
DHCP Enabled:
No
NOTE
If the information for the Ethernet adapter displays "Media Disconnected," close the command prompt
and go to Step 2: Disable DHCP to use the computer's existing IP address (on page C-4).
3. When the information is displayed, record the following information for the correct network card:
• DHCP mode: _______________________________
• IP address: ________________________________
• Subnet mask: ______________________________
• Default gateway: ____________________________
• DNS servers: _______________________________
CAUTION
The ipconfig/all command displays the configuration of every network card. Make sure that you
record the information for the proper network card.
To Next Page
Loading...
