249
Global edit mode
Voice Processor Preset: Harmony Voices
Reference
Smooth
Sets how much of the input pitch nuance is applied to the output
voice. Not applicable to Shift presets.
Harmony Note Input
In Style Play and Song Play mode, when the Harmony track is
set to Global, the Voice Processor’s Harmony module can receive
notes and chords from a source different than the Arranger’s
Chord Scanning area. This way, you can continue sending
chords to the Arranger with your left hand, while, for example,
sending chords or notes to the Harmony module with your right
hand.
Source
This parameters allows you to select a source of notes or chords
for the Harmony module of the Voice Processor.
Chord Scanning
With this option selected, notes or chords come
from the same chord scanning area dedicated to
the Arranger. (This works exactly as in the previous
versions of the operating system).
Lower Notes or chords come from the Lower area of the
keyboard.
Upper Notes or chords come from the Upper area of the
keyboard.
Full Keyb. Notes or chords come from the full range of the
keyboard.
Harmony Voices Envelope
The envelope lets you set a different Attack and Release time for
the harmony voices.
Note: The envelope can only work when the “Latch On/Off”
parameter is turned off (see page 248).
Attack
Sets the envelope attack time for harmony voices. Available only
in Notes and Chord mode.
Release
Sets the envelope release time for harmony voices. Available only
in Notes and Chord mode.
Level
Level knob
Sets the overall harmony voices level.
Voice Processor Preset: Harmony Voices
The Voice Processor can add up to four Harmony Voices to the
Lead voice. Here you can adjust parameters for each individual
voice.
Voice Select buttons
V1…V4
Use these buttons to select one of the four available voices for
editing.
Individual Voice Basic
Voice On/Off
This checkbox allows enabling/disabling of the selected Har-
mony Voice. It is the same control found on the “Preset” page.
Gender
This parameter sets the formant of the Harmony Voice. Use it to
alter the character of the voice ranging from -50 (a big person
with a deep voice) to 0 (no change) to +50 (mice/alien sound).
Voicing
This parameter is used to set the voicing of the selected voice.
This parameter means different things depending on the har-
mony mode of the preset.
Scale Mode Presets
In this mode the Voicing parameter specifies the interval of the
harmony note with respect to the input note in the scale. The
range of values goes from --8, which is 2 octaves below the input
note, to ++8 which is two octaves above the input note, or Cus-
tom Map, which means custom voicing (See “Custom Voice
Mapping” below). For example, a setting of +3 will result in a
harmony voice a third above the input voice, related to the cur-
rent scale.
Chord Mode Presets
In this mode the Voicing parameter specifies the relation of the
harmony note to the input note with respect to the current
chord. In Chord mode presets, the harmony voices are always
notes in the chord. A setting of Up1 will result in the harmony
voice being the next note above the input voice in the chord. For
instance, if the chord was C Major and the input note was an E,
an Up1 setting would produce a G harmony voice, just above the
input E.
VPp
VPp
VPp
VPp
VPp
Voice
Select
buttons
VPp
VPp
VPp
VPp
To Next Page
Loading...
Need help?
General
